Filter
QMC470 – 40-Channel TTL/CMOS Digital I/O
The QMC470 is a VITA 93 module providing 40 bidirectional digital I/O channels. It combines TTL-compatible inputs, CMOS open-drain outputs up to 15 mA, programmable interrupts and debounce, output readback and PCIe connectivity for high-density embedded I/O systems.
QMC450 – 32 Isolated Digital Outputs
The QMC450 is a VITA 93 module providing 32 isolated bipolar solid-state relay outputs. It switches AC or DC signals up to ±60 V, with high-side or low-side configuration per 8-channel port, output readback, failsafe reset and PCIe host connectivity.
QMC440 – 32 Isolated Digital Inputs
The QMC440 is a VITA 93 module providing 32 optically isolated bipolar digital inputs. Four isolated 8-channel groups, programmable interrupts and debounce, three voltage ranges and air- or conduction-cooled configurations support high-density discrete monitoring in embedded systems.
QMC350 – 20-Channel 16-bit Analog Input / 1 MSPS
The QMC350 is a VITA 93 analog-input module providing 20 simultaneous channels, each with a dedicated 16-bit 1 MSPS ADC. Per-channel voltage-range selection, digital filtering, software calibration and a PCIe Gen2 x4 interface support compact high-density data-acquisition systems.
VPX7600
The VPX7600 is an I/O Intensive single board computer featuring an Intel 11th Generation Xeon W-11000E Series processor. It was developed in alignment with the Sensor Open Systems Architecture (SOSA) Technical Standard.
AP570
AP570 communication module with dual MIL-STD-1553 channels, four discrete avionics-grade I/O signals, high performance and low power consumption.
ACPS3310
The ACPS3310 is a 3U CompactPCI Serial carrier card designed for Acromag’s AcroPack mezzanine modules. It provides two isolated I/O expansion slots that connect AcroPack or mini-PCIe modules to the PCIe bus.
AMC720 – Xeon E3 Processor AMC with PCIe
The AMC720 is an Intel Xeon E3 AdvancedMC processor module with up to four cores, 16 GB DDR3 ECC, PCIe, dual Gigabit Ethernet, SATA and IPMI 2.0. The AMC720C variant supports conduction-cooled MicroTCA systems.
AMC705 – 16-Core Processor AMC with 100GbE
The AMC705 is an AdvancedMC processor module based on the NXP Layerscape LX2160A. It combines 16 Arm Cortex-A72 cores, 16 GB DDR4 ECC, QSFP28 connectivity up to 100GbE and configurable rear Ethernet, SRIO and PCIe interfaces for high-bandwidth MicroTCA systems.
AMC535 – Arria 10 SoC SX660 AMC/FMC FPGA Carrier
The AMC535 combines an Arria 10 SoC SX660 FPGA, a 1.2 GHz dual-core Arm Cortex-A9 processor, 16 GB DDR4 and a VITA 57 FMC site. FPGA-programmable AMC interfaces support PCIe, SRIO, Aurora and 1/10/40GbE for high-speed MicroTCA signal-processing systems.
AMC352 – Quad HDMI/DVI Video Decoder
AdvancedMC multichannel video-decoder module with four HDMI/DVI outputs, H.264, VC-1, MPEG and additional codec support up to Full HD 1920 × 1080 at 60 FPS, with PCIe or Gigabit Ethernet data transport.
AMC225 – 10GbE/XAUI Media Converter & Network TAP
AMC.2 module with two front-panel 1/10GbE SFP+ ports and a 10GbE XAUI backplane interface, providing media conversion, direct port connectivity and physical-layer traffic mirroring.
FMC272 – Quad 12 GSPS RF DAC & Dual 6 GSPS RF ADC
The FMC272 is a VITA 57.1 FMC module based on the Analog Devices AD9082. It combines four 16-bit 12 GSPS RF DACs, two 12-bit 6 GSPS RF ADCs, 8 GHz analog bandwidth and eight JESD204B/JESD204C lanes for high-speed RF generation and acquisition.
VME218 – 6U VME Gigabit Ethernet Switch up to 24 Ports
The VME218 is a managed Layer 2 Ethernet switch in 6U VME form factor. Its baseboard provides 12 Gigabit RJ-45 ports and can be expanded to 24 ports using an SFP or copper daughter card, with VLAN, QoS, Spanning Tree, ACL and network-security functions.
TQMC802 – 4 Isolated CAN FD Channels
The TQMC802 is a VITA 93.0 QMC module integrating four independent isolated CAN FD interfaces. Each channel supports CAN FD and Classic CAN at data rates up to 5 Mbps, with message filtering, configurable termination and fault-protected isolated transceivers.
TQMC801 – 1000BASE-KX Ethernet QMC
The TQMC801 is a VITA 93.0 QMC module integrating one 1000BASE-KX Ethernet channel and an Intel I210IS controller. It supports IEEE 1588/802.1AS PTP synchronization, IEEE 802.1Qav AVB traffic shaping and PXE/iSCSI network boot.
TQMC605 – QMC FPGA with 40 Direct I/Os
The TQMC605 is a VITA 93.0 QMC module featuring a user-programmable AMD Artix 7 FPGA. Its 40 I/O lines connect directly to FPGA pins to preserve Artix 7 SelectIO™ flexibility, with external ESD protection on every line.
TQMC604 – 32 Isolated 5–36 V Digital Outputs
The TQMC604 is a VITA 93.0 QMC module with 32 isolated digital outputs. Each output operates from 5 to 36 V DC at up to 0.15 A, with high-side or low-side switching per group of eight, electrical protection and a hardware watchdog.
TQMC603 – 20 Isolated Digital Outputs
The TQMC603 is a VITA 93.0 QMC module with 20 isolated 5–36 V digital outputs. Each channel delivers up to 0.3 A and can operate as high-side, low-side or push-pull, with electrical protection, individual fault monitoring and a hardware watchdog.
TQMC602 – 16 Isolated Digital Inputs / Outputs
The TQMC602 is a VITA 93.0 QMC module combining 16 isolated digital inputs and 16 isolated digital outputs. It supports 15–60 V inputs and 5–36 V outputs up to 0.3 A per channel, with programmable interrupts, debouncing and a hardware watchdog
TQMC601 – 32 Isolated Digital Inputs
The TQMC601 is a VITA 93.0 QMC module with 32 isolated digital inputs for 15 to 60 V DC signals. It combines galvanic isolation, configurable interrupts and programmable debouncing for fast digital-state acquisition in embedded systems.